Interface Force - Multi-axis force sensors (load cells), Pressure Sensor & Pressure Transmitters, Sensor Instrumentation, Custom Designs and Dynamic Pressure Mapping.

Use our live chat service to speak to an operator directly

Gold Std.Calibration & Test Frame

Gold Std.Calibration & Test Frame

4 Post Calibration Test Stand

  • Choice of capacites 3,000lb (13.5kN) to 55,000lb (245kN)
  • Load Frame includes upper platen, columns, nuts, slack adapter etc
  • 3,000psi hydraulic actuator, including piston,cylinder, seals and fittings
  • 4 post stand includes base structure
  • Interface 1200 series load cell used as control cell

Interface's Automated Calibration System, for calibrating load cells, uses a rigid mechanical frame with precison alignment between fixed base plate and fixed cross head. The load frame provides an incrementally adjustable test space capable of compensating for minute differences in calibration assembly length. Workspace* is stabilized via four 2-inch smooth, chrome plated columns - allowing for ample clearspace between columns and a high-test space adequate for most load cells. The hydraulic actuator movement provides for accurate tension and compression measurements, both in a single installation made possible by a unique slack adapter. Included software supports ASTM E74 and ISO-376 test

  • Choice of capacites 3,000lb (13.5kN), 10,000lb (44.5kN) or 55,000lb (245kN)
  • Load Frame includes upper platen, columns, nuts, slack adapter with  precision alignment
  • 3,000psi hydraulic actuator, including piston,cylinder, seals and fittings
  • 4 post stand includes base structure
  • Air/ oil cooled
  • Electronic measurement and coltrol for standard channel plus one test channel
  • Choice of reference cells
  • Interface 1200 series load cell used as control cell
  • Optional  software utility is available to write TEDs (IEEE1451.4 std.) data to TEDs- capable loadcells, utilizing Template 33.

  • Please down load the data sheet for full specifications 

     

    • Printer
    • Optional  software utility is available to write TEDs (IEEE1451.4 std.) data to TEDs- capable loadcells, utilizing Template 33
    • Metrology grade load cells
    • Third or fourth channel for calibration of dual or triple bridge load cells
    • Interface CX reference simulator
    • Traning
    • On site set-up
    • Thread adaptors
    • Load frame including upper platen, columns, nuts, slack adapter
    • Actuator including piston, cylinder, seals, fittings
    • 4 post stand, including base structure and panels
    •  Hydraulic pump
    • Servo valve assembly
    • Air /oil cooler
    • Electronic measurement and control for standard channel. Includes BD90 servo amplifier, industrial computer, LVDT position sensor, momentary down switch, wiring and hardware
    • SGA amplifier
    • 1200 series control load cell
    • DA-101 control board
    • Gold Standard cables x2
    • SCBI or HRBSC measurement board (2 channels)
    • ICS-202 hydraulic control and data analysis software

     

    Product page last updated: 2015-06-02 16:23:30